Marantz PM7000 Stereo Amplifier User Manual


 
English
English
Français
Français
8
OPERATION
TO PLAY AN ANALOG RECORD
1. Set INPUT SELECTOR to PHONO.
2. Play the record on the turntable.
3. Use VOLUME to adjust volume, and BASS and TREBLE
to adjust the tone.
NOTE:
Be sure the set VOLUME to is minimum setting before
placing the stylus onto the record or before replacing the
turntable’s cartridge.
Never subject the turntable to shock or vibration while a
record is playing. This can cause the stylus to jump and
possible damage the record.
Locating your turntable too close to the speakers can
cause howling, which will make it impossible to use higher
volume settings.
Never turn off power while the stylus is in contact with
the surface of the record.
TO LISTEN TO AN FM/AM BROADCAST
1. Set INPUT SELECTOR to TUNER.
2. Tune in the desired station on the tuner.
3. Use VOLUME to adjust volume, and BASS and TREBLE
to adjust the tone.
TO PLAY A COMPACT DISK
1. Set INPUT SELECTOR to CD.
2. Play a CD on the CD player.
3. Use VOLUME to adjust volume, and BASS and TREBLE
to adjust the tone.
TO PLAY EQUIPMENT CONNECTED TO THE AUX 1
OR AUX 2 JACKS
1. Set INPUT SELECTOR to AUX1 or AUX2.
2. Set up the connected equipment for play.
3. Use VOLUME to adjust volume, and BASS and TREBLE
to adjust the tone.
!9 Record (REC) Selector Switch
Use this switch to select recording between the tape deck
and CD-R(MD) or recording of the signal selected by the
INPUT SELECTOR SWITCH and output from the REC OUT
jacks. See the note under "Tape Deck CD-R(MD) Operation
on page 9 for full details about settings.
@0 Source Direct Switch
Press this switch to turn source direct on (depressed) and
off (raised).
When source direct is turned on, the audio signal path is as
short and direct as possible in order to enjoy high-quality
sources under the best conditions possible.
NOTE:
Tape and CD-R(MD) playback and recording are not
possible when the SOURCE DIRECT switch is on. The
TONE and BALANCE controls are also disabled. Any
graphic equalizer or other such component that is
connected to the PROCESSOR IN/OUT jacks will not have
any effect. In order to use any of these components or
controls, it is necessary to turn the SOURCE DIRECT switch
off.
@1 Bass and Treble Tone Controls
Use these controls to control the levels of their corresponding
frequency bands. TREBLE adjusts the high frequency band,
while BASS adjusts the low frequency band. Rotating a
control towards (+) enhance the frequency band, while
rotating towards (–) attenuates the frequency band.
@2 Seaker Switches 1/2
Use these switches to turn speaker output on (depressed)
and off (raised). You can turn off speaker output when
listening to output over headphones.
@3 Phones Jack
Use the jack to plug in headphones that are equipped with a
standard phone jack.
@4 Standby Indicator
This indicator is lit while the amplifier is in the Standby Mode.
Pressing the remote control unit’s POWER buttons switches
the amplifier between standby and power on.
2 Perform the applicable operation on the connected
equipment.
INTEGRATED AMPLIFIER PM7000
INPUT SELECTOR VOLUME
POWER ON/OFF 1 2SPEAKERSSTANDBYPHONES
OFF
REC SELECTOR
TAPE PHONO CD
TUNER AUX1 AUX2
TAPE
CD-R/MD
CD-R/MDMUTE
BASS
SOURCE
SOURCE DIRECT
OFFONOFFON +
-
R
L
+
-
TREBLE BALANCE
MAXMIN
COPY
TAPE CD-R
CD-R TAPE
1
3
3