Filter
Top Products
23
ENGLISH
3. After A side program complete, player turns to the pause
state at the beginning of B side program.
4. When A side of the tape ends up, cassette deck inverts
its recording direction and set to rec pause state
automatically.
5. Press 3 or 8 buttons of the player manually to start B side
recording. Player sends out signal to restart recording and
starts playing B side program after 4 seconds.
6. After B side program complete, player stops playing and
clears edit program automatically.
Note:
• If the tape ends up before edit program of one side
completes, for example by wrong tape length have
chosen, cassette deck send out signal to player to let
the player cancel the rest of program. Player jumps to
the beginning of B side if it was A side or stop playing
and clear edit program if it was B side.
• Synchro recording can be started only when a Marantz
autoreverse cassette deck (ex. SD4050 etc.) with synchro
recording compatibility is connected to the CD player.
• Synchro recording is performed through the remote line
connection (rear panel jacks).
• Program edit
This procedure allows you to record tracks in any desired
order while fitting the tracks into a specified tape length.
1. Program tracks according to the programming procedure
in section “PROGRAM PLAY” (page 17).
2. The rest of the program edit procedure is the same as
step 1 to 3 in the simple edit procedure.
• Delete program edit
When recording from a disc to a tape, this procedure allows
you to omit the tracks you do not want to record, while fitting
the tracks into a specified tape length.
1. Program tracks according to the “delete programming”
procedure in the “PROGRAM PLAY” section (page 19).
2. The rest of the delete program edit procedure is the same
as step 1 to 3 in the simple edit procedure.
Note:
• During the simple edit play, program edit play and delete
program edit play, any operations other than the STOP,
OPEN/CLOSE and TIME Display OFF buttons are
disabled. This is intended to prevent mistakes in
recording due to erroneous operation.
• While editing, remote control operations are disabled.
• The display is always in the time display mode during
edit play. It is not possible to switch to the text display
mode.
• Start Edit Recording
Before start editing, connect remote control input of Marantz
cassette deck with remote control output of CD5001 by remote
control cable.
Reverse mode switch may be set to any of one side ( ),
both sides (
) and continuous play ( ).
- Synchro recording with Marantz auto reverse cassette
deck set to both sides ( ) or continuous play ( )
mode.
1. After setting up, setup the cassette deck to rec pause
state.
2. Press 3 or 8 buttons of the player to start A side program.
The player sends out signal to start recording and starts
playing A side program after 4 seconds.
TTL
TRK
TTL
TIME
A
–
EDIT
TEXT
12 34 56 78 910 11121314 15
TTL
TRK
TTL
TIME
B
EDIT
TEXT
16 17 18 19 20
Total number of tracks on side B
Total playing time
of side B
Number indicators of tracks assigned to side B light up.
ADVANCED OPERATIONS
05.7.6, 9:07 AMPage 23