Filter
Top Products
7
ANT 75‰
L/Mono
Monitor out
VIDEO
S-VIDEO
AV1 in
Y
Pb
Pr
AV2 in
AUDIO
R
COMPONENT VIDEO INPUT
1
T
he Cable TV input into your home may be a
single (75 ohm) cable. If so, this connection is
very simple. Follow the steps below to connect
your cable signal to your new television.
Direct Cable Connections:
1
Connect the open end of the round
Cable Company supplied cable to
the 75Ω input on the TV. Screw it
down finger tight.
BASIC CABLE TV CONNECTION
Back of TV
Direct Cable Connection:
Cable signal coming
from Cable
Company (Round
75Ω coaxial cable)
Jack Panel Back of TV
A
combination antenna receives normal broad-
cast channels (VHF 2–13 and UHF 14–69).
Your connection is easy because there is only one
75Ω (ohm) antenna plug on the back of your
TV, and that’s where the antenna goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has a flat, twin-
lead wire (300 ohm), you first need
to attach the antenna wires to the
screws on a 300- to 75-ohm adapter.
2
Push the round end of the adapter
(or antenna) onto the 75Ω (ohm) plug
on the back of the TV. If the round
end of the antenna wire is threaded,
screw it down finger tight.
BASIC ANTENNA CONNECTION
After using the AutoProgram Control, press
the CH + and – buttons to scroll through all
the channels stored in the television’s memory.
HELPFUL HINT
1
2
ANT 75‰
L/Mono
Monitor out
VIDEO
S-VIDEO
AV1 in
Y
Pb
Pr
AV2 in
AUDIO
R
COMPONENT VIDEO INPUT
Back of TV
Round 75Ω
Coaxial Cable
from Antenna
Twin
Lead Wire
300 to 75-ohm
Adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
Antenna Connection:
Jack Panel
Back of TV