Filter
Top Products
Danish Interpretation Systems User Manual
Manual 01 18 04442
8
User controls, indications & connections
Front plate layout
The front plate layout of the AO 6004 Audio Output Unit consists of 4 XLR analogue transformer balanced
outputs and 2 DCS-LAN connectors:
Front plate controls and indicators
The AO 6004 is an easy to use AO unit with pre-
configured settings and no user interface in terms of
controls, display or indicators.
Front plate connectors
Audio Output A to D
On the front are located 4 XLR 3P connectors, each
supplying transformer balanced audio signal from
each of the 4 channels.
The outputs can be used for tape recording purpose
i.e. or for connecting a digital infrared transmitter
like DT 6008, DT 6032 or analogue infrared
transmitter IT6108 for wireless transmission of the
interpreted languages.
DCS-LAN connector
Two RJ45 sockets are located at the front of the unit
for connecting to the previous unit like the CU
6005/6010 Central Unit or any other unit with a
DCS LAN connector and to the next unit like an IS
6132 Interpreter set, CS 6032 Channel Selector,
DM/CM 6xxx Conference Unit.
System settings
Pre-configured settings
The AO 6004 comes with pre-configured settings
and can be used without additional configurations.
The AO 6004 automatically assigns channels to the
outputs at start-up. Output A is assigned channel 0
(Floor), Output B is assigned channel 1, Output C is
assigned channel 2 and Output D is assigned
channel 3.
The output volume for each channel is +3 dB,
which is the recommended level for connecting to
DT 60xx.
The unit can be re-configured using SW 6000. The
settings for a reconfigured unit can be saved in the
CU 6005/6010.
SW6000 settings
The SW6000 can be used for changing the
assignment of channels to outputs and for setting
the volume.
Both the Conference Administration Application
(CAA) and the Conference User Application (CUA)
can be used to configure the AO units connected.
They both have settings for assigning channels to
each of the 4 outputs A-D. Each output can be set to