Filter
Top Products
Danish Interpretation Systems User Manual
Manual 01 18 04442
11
Typical schematics
Connect the AO 6004 to the DCS 6000 network
using Cat 5 cables. The Analogue Audio output
connectors are connected to either tape recorders
for recording the interpreted channels or to IT6008
Infrared Transmitter(s) for transmitting the
interpreted channels wireless.
Using AO 6004 with IT 6108 IR-Transmitter
When using the AO 6004 with the IT 6108 Infrared
Transmitter, the audio output level on the AO 6004
has to be set to match the sensitivity on the
transmitter.
The correct level to be set on each connected
channel on the AO 6004 is –12db.
Using AO 6004 with DT 60xx Digital IR-Transmitter
When using the AO 6004 with the DT 60xx
Infrared Transmitter, the audio output level on the
AO 6004 has to be set to match the sensitivity on
the transmitter.
The correct level on each connected channel on the
AO 6004 is +3dB. This level is factory preset, but
can as earlier mentioned be changed using SW
6000. Please refer to the section ‘Pre-configured
settings’ on page 8. The DT 60XX input level
settings should be set to –6dB.