Filter
Top Products
English
KNEKT Multi-room
Owner's Manual
KNEKT RCU operation
Clock feature
TToo ddiissppllaayy tthhee cclloocckk::
●
Press repeatedly to step you through the clock display options
available – i.e. time with seconds; time without seconds; date; day and
time.
TToo sseett tthhee cclloocckk::
●
Press , and then and
DDOO
simultaneously.
The display shows the current time, with the hours flashing.
●
Use the
‘‘mmuullttii--ffuunnccttiioonn’’
keys to change the value of the flashing number,
or
DDOO
to select the next time or date field.
●
When you have set the required time and date, press to store the
new values and start the clock. Pressing any other key cancels the
changes you have made, and restores the original time and date.
Note:
When the time is updated, any alarm settings stored in the KNEKT RCU (see the
Alarm Function
section later in this manual) will be cancelled.
To perform a system clock update (INTERSEKT based systems only):
If your KNEKT system incorporates the INTERSEKT, at the end of the above
sequence the following display will appear:
‘System time update?’
And the ‘X’ ‘ ’ options will appear above the
‘‘mmuullttii--ffuunnccttiioonn’’
keys.
●
Press the right hand
‘‘mmuullttii--ffuunnccttiioonn’’
key (below the ‘ ’ ), to update all
KNEKT RCU clocks in the system.
OR
●
Press the left-hand
‘‘mmuullttii--ffuunnccttiioonn’’
key (below the ‘X’), to update only the
KNEKT RCU in that room.
CCoonnttrroolllliinngg tthhee KKNNEEKKTT ssyysstteemm bbyy rreemmoottee ccoonnttrrooll
If you have a Linn remote control handset that includes the
WWHHEERREE
,
WWHHAATT
,
DDOO
and
‘‘mmuullttii--ffuunnccttiioonn’’
keys, then this can be used to control the KNEKT RCU. Use
these keys exactly as you would use the equivalent keys on the KNEKT RCU
(see
KNEKT RCU operation
, above).
The KNEKT RCU’s standard preamplifier functions (volume +/-, mute, balance
etc) can also be controlled, using the corresponding keys on the handset.
Note:
If your KNEKT RCU does not respond to the KNEKT commands from the remote
control, please check firstly that the remote control handset is functioning
(perhaps check it using another Linn product). If the handset is functioning but
will not control the KNEKT RCU, it may be that the KNEKT RCU has been
programmed so that its remote control sensor is disabled. Please consult your
Linn Custom Installer.
8