Linn Klout Stereo Amplifier User Manual


 
ii
MAINS PLUGS
This appliance is supplied with a non-rewireable mains plug for the intended
country.
Replacement mains leads can be obtained from your Linn retailer.
Should you need to change the plug please dispose of it carefully.
A plug with bared conductors is dangerous if engaged in a live socket.
The Brown wire must be connected to the Live (Line) supply pin.
The Blue wire must be connected to the Neutral supply pin.
The Green/Yellow wire must be connected to the Earth (Ground) supply pin.
Please contact your retailer or a competent electrician if you are in any doubt.
GENERAL SAFETY INSTRUCTIONS
1. Read Instructions. Read the safety and operating instructions before
operating the appliance.
2. Retain Instructions. Retain the safety and operating instructions for future
reference.
3. Heed Warnings. Observe all warnings on the appliance and in the
operating instructions.
4. Follow Instructions. Follow all operating and use instructions.
5. Water and Moisture. Do not use the appliance near water, for example near
a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near
a swimming pool and the like.
6. Carts and Stands. Use only with a cart or stand that is recommended by the
manufacturer.
6a. An appliance and cart combination should be used with care. Quick stops,
excessive force and uneven surfaces may cause the appliance and cart
to overturn.
7. Wall or Ceiling Mounting. Mount to a wall or ceiling only as
recommended by the manufacturer.
8. Ventilation. Site the appliance so that its location or position does not
interfere with its proper ventilation. For example the appliance should not
be situated on a bed, sofa, rug or similar surface that may block the
ventilation openings; or placed in a built-in installation such as a
bookcase or cabinet that may impede the flow of air through the
ventilation openings.
9. Heat. Site the appliance away from heat sources such as radiators, heaters,
stoves or other appliances (including amplifiers) that produce heat.
10. Power Sources. Connect the appliance to a power supply only of the type
described in the operating instructions or marked on the appliance.