Filter
Top Products
6
CAUTION When passively bi-amping or tri-amping loudspeakers remove any
connecting links that are at the speaker input terminals. Failure to do this will
short the amplifier outputs together and may damage the power amplifier.
OUTPUT CONNECTIONS
Connection of the KLOUT to the loudspeakers should be made with a good
quality cable. We recommend the use of Linn K series speaker cable and Linn
KNEKT speaker plugs.
Linn speaker cable is marked with the Linn logo to indicate directionality. The
cable should be connected to the amplifier with the logo pointing towards the
loudspeaker.
Ensure that the wiring is correct. The red socket is positive and the black is
negative. The positive wire (red connector) is identified by a rib along the side
of the K20 cable.
NOTE
When using the Linn KAIRN pre-amplifier, or another phase inverting
pre-amplifier, the signal to the KLOUT is inverted. Therefore, to maintain
absolute phase, connect the positive output of the KLOUT to the negative
(black) loudspeaker terminal, and the negative output to the positive (red)
loudspeaker terminal.