Filter
Top Products
9
GENERAL SYSTEM INSTALLATION
TURNT
ABLES For best results a turntable should be placed on a small, light,
rigid table, or alternatively wall mounted on a light, rigid shelf.
CD PLA
YER The KARIK and NUMERIK should be positioned on a level
surface. Extensive internal screening in the KAIRN pre-amplifier, KREMLIN
tuner, KARIK and NUMERIK facilitates stacking the products one on top of the
other without interference, if desired.
POWER SUPPLIES
Take care not to position too close to signal leads,
turntables or pre-amplifier.
AMPLIFIERS
Pre and power amplifiers may hum is positioned too close
together. For minimum hum, experiment by moving the components with
the system at full volume but not playing music (although it is best to turn the
volume down whilst actually moving the components). The KLOUT power
amplifier has a screened transformer which enables it to be positioned close
to other audio products in your system without interference. Position the
KLOUT to allow free movement of air around the heatsinks. Do not stack a
KLOUT with other products which will obstruct the airflow, or which cannot
support the weight.
LOUDSPEAKERS
Loudspeakers should be positioned correctly. They should
be mounted on rigid stands and not subject to any rocking movement.
CLEAN CONT
ACTS It is important that the electrical contacts in a hi-fi
system are kept mechanically sound and clean. Occasionally unplugging and
re-plugging all the connectors will effectively clean contacts.
W
ARNING This should be carried out after the mains supply has been
switched off.
INTERCONNECT LEADS
Correct cables should be used. We recommend
good quality copper cable for interconnect leads and advise 4mm
2
multicore
copper cable, such as Linn K20, for speaker leads.
Your Linn dealer can supply high quality interconnects for linking all your hi-fi
components.