Filter
Top Products
26
To Configure the Amplifier for FourTo Configure the Amplifier for Four--Channel UseChannel Use
11 Connect the left channel 1 interconnect from your pre-amp or
source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22 Connect the right channel 1 interconnect from your pre-amp or
source component to the CHANNEL 4 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 4
BAL/UNBAL switch towards the connector that is being used.
33 Connect the left channel 2 interconnect from your pre-amp or
source component to the CHANNEL 3 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 3
BAL/UNBAL switch towards the connector that is being used.
44 Connect the right channel 2 interconnect from your pre-amp or
source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
55 Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 5 TO 4. Flip the LINK INPUT 3 TO 2/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2.
66 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 2 to CHANNEL
3.
77 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 4 to CHANNEL
5.
88 Connect your left channel 1 loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99 Connect your right channel 1 loudspeaker cable to the Channel
5 SPEAKER OUTPUT connector.
1010 Connect your left channel 2 loudspeaker cable to the Channel 3
SPEAKER OUTPUT connector.
1111 Connect your right channel 2 loudspeaker cable to the Channel
6 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.