Filter
Top Products
18
To Configure the Amplifier for TwoTo Configure the Amplifier for Two--Channel Stereo, HChannel Stereo, High Current Useigh Current Use
11 Connect the left channel interconnect from your pre-amp or
source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22 Connect the right channel interconnect from your pre-amp or
source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
33 Flip the LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 2 TO 1. Flip the LINK INPUT 3 TO 2/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2. Flip the
LINK INPUT 6 TO 5/UNLINK (NORMAL) switch “ON”, or up towards
LINK INPUT 6 TO 5. Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL)
switch “ON”, or up towards LINK INPUT 5 TO 4.
44 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 1 to CHANNEL
2 and CHANNEL 2 to CHANNEL 3.
55 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 6 to CHANNEL
5 and CHANNEL 5 to CHANNEL 4.
66 Connect your left loudspeaker cable to the Channel 1 SPEAKER
OUTPUT connector.
77 Connect your right loudspeaker cable to the Channel 6 SPEAKER
OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.