Filter
Top Products
16
To Configure thTo Configure the Amplifier for Singlee Amplifier for Single--Channel Monoblock UseChannel Monoblock Use
11 Connect the left or right channel interconnect from your pre-
amp or source component (depending on which channel of
operation the amplifier is to be used for) to the CHANNEL 1
balanced XLR or unbalanced RCA input connector. Select the
correct balanced or unbalanced input connector by flipping the
Channel 1 BAL/UNBAL switch towards the connector that is being
used.
22 Flip the LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 2 TO 1. Flip the LINK INPUT 3 TO 2/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2. Flip the
LINK INPUT 4 TO 3/UNLINK (NORMAL) switch “ON”, or up towards
LINK INPUT 4 TO 3. Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL)
switch “ON”, or up towards LINK INPUT 5 TO 4. Flip the LINK INPUT 6
TO 5/UNLINK (NORMAL) switch “ON”, or up towards LINK INPUT 6 TO
5.
33 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 1 to CHANNEL
2, CHANNEL 2 to CHANNEL 3, CHANNEL 3 to CHANNEL 4,
CHANNEL 4 to CHANNEL 5, and CHANNEL 5 to CHANNEL 6.
44 Connect the corresponding left or right loudspeaker cable to the
Channel 6 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.