Filter
Top Products
1.Insert the stereo audio cables (included) into the AUX INPUT L (left=white) and R (right=red) jacks or any available
set of input jacks on the back of your HOME THEATER SYSTEM, and into the corresponding AUDIO OUT jacks on
your VCR, this will allow your VCR’s sound to play through your HOME THEATER SYSTEM.
2.Connections of your cables are not changed when you add your HOME THEATER SYSTEM.
NOTE: You will hear sound from both the TV and your HOME THEATER SYSTEM, this is normal.
3.Insert the AC power cord into an AC outlet.
4.Make sure the POWER switch on the back of the main unit is at “ON” position. Next press the ON/STANDBY button
on the front of the main set or on the REMOTE to turn the set on (or off).
NOTE:The factory’s default input source is DVD with 5.1 channel sound output. When the set is turned to ON, the
DVD indicator and 5.1 channel indicator will be on and sound will come out of 5 speakers plus the subwoofer.
To change 5.1 channel to 2 channel output, press the SPEAKER CHANNELS button. The sound will come out of
only 2 front speakers plus the subwoofer.
5.Press the INPUT SOURCE button several times till the AUX indicator lights.
6.Make sure your VCR is on and follow your VCR’s instructions.
7.Go to Page 21 for other detailed instructions.
TV + VCR CONNECTIONS
14
Home Theater System + TV + VCR
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8 (OR THE QUICK SETUP DIAGRAM SHEET)
This does not change
from your current connection.
CABLE OR
ON AIR ANTENNA/
SATELLITE SIGNAL