Filter
Top Products
IB-HT377-WM-E-050405
5
LOCATION OF CONTROLS
FRONT PANEL
1. REMOTE SENSOR - Receives the signal from
the REMOTE CONTROL (aim theREMOTE
control towards this sensor).
2.ON/STANDBY button - Press to switch the
set to on or standby mode.
3.ON/STANDBY indicator - This indicator has
2 modes: flashing and steadily on (slow flashing
indicates the set is in standby, steadily on indicates
the set is on). When the set is turned to ON,
pressing the ON/STANDBY button on the main
set or on the REMOTE CONTROL will turn
the set to the standby mode, the indicator will
become slow flashing.
NOTE: The power switch on the back of the
main set must be ON.
4.VOLUME + button - Increases the volume.
5.VOLUME - button - Decreases the volume.
6.SOURCE button - Press to select the sound
input source you want: DVD or MP3/AUX.
7.DVD indicator - For DVD sound use, press the
SOURCE button on the main set or on the remote
control till this lights.
8.MP3 indicator - For MP3, PC or other component’s
output sound use, press the SOURCE button on
the main set or on the remote control till this lights.
9.DVD AUDIO INPUT jacks - Connect to the
audio output of a DVD player or other component
with AUDIO output jacks to have 2.1 channel
sound.
1
2
3
4
5
6
7
8
ON
STANDBY
VOL
VOL
SOURCE
DVD
MP3
+
10.MP3/AUX INPUT jack - Connect to the audio
output of an MP3 or PC or tape deck or other
component using a 3.5 mm audio output plug.
11.LEFT SPEAKER jacks - Connect one of the
SPEAKERS to the grey and black terminals.
12.RIGHT SPEAKER jacks - Connect one of the
SPEAKERS to the grey and black terminals.
13.FUSE HOLDER with screw cover.
14.AC LINE CORD - Connect to a 120V/60Hz
AC standard wall outlet.
15.POWER switch - Press to power the set on or off.
NOTE: This switch must be ON in order to be
able to use the ON/STANDBY button on the
main set or on the REMOTE CONTROL.
BACK OF MAIN SET
(SUBWOOFER)
9
11
9
11
13
12
12
14
15
10
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM6