Filter
Top Products
IB-HT377-WM-E-050405
1. Insert the stereo audio cables (included) into the DVD INPUT LEFT and RIGHT jacks on the
back of your HOME THEATER SYSTEM, and into the corresponding AUDIO output jacks
on your VCR, this will allow your VCR’s sound to play through your HOME THEATER
SYSTEM.
2. Connections of your other antenna cables are not changed when you add your HOME
THEATER SYSTEM. You will hear sound from both the TV and your HOME THEATER,
this is normal.
3. Insert the AC power cord into an AC outlet.
4. Make sure the POWER switch on the back of the main set is at “ON” position. Next press
the ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to
switch the set on (or standby).
5. Press the SOURCE button till the DVD indicator lights.
NOTE:The factory’s default input source is DVD. When the set is turned to ON, the DVD
indicator will be on, press the SOURCE button to turn on the MP3 indicator if you use
the 3.5 mm plug audio cable.
6. Go to Page 15 for other detailed instructions.
TV + VCR CONNECTIONS
Home Theater System + TV + VCR
CONNECT THE SPEAKERS AS SHOWN ON PAGE 8 (OR THE QUICK SETUP DIAGRAM SHEET).
NOTE: On some TVs, this
jack is in the front.
ANTENNA CABLE OR
OFF-AIR SIGNAL
This does not change from
your current connection.
RIGHT
LEFT
AUDIO
D
V
D
I
N
P
U
T
M
P
3
A
U
X
I
N
P
U
T
RED
WHITE
RED
WHITE
12
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM13