Filter
Top Products
IB-HT377-WM-E-050405
1. Insert the stereo audio cables (included) into the DVD INPUT LEFT and RIGHT jacks on the
back of your HOME THEATER SYSTEM, and into the corresponding AUDIO output jacks
on your DVD player, this will allow your DVD’s sound to play through your HOME THEATER
SYSTEM.
2. Insert the video cable into the VIDEO OUT jack on the back of your DVD player and into
the VIDEO IN jack on the back of your TV set. This is especially convenient if your TV has
several inputs.
3. Insert the AC power cord into an AC outlet.
4. Make sure the POWER switch on the back of the main set is at “ON” position. Next press
the ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to
switch the set on (or standby).
5. Press the SOURCE button till the DVD indicator lights.
NOTE:The factory’s default input source is DVD. When the set is turned to ON, the DVD
indicator will be on, press the SOURCE button to turn on the MP3 indicator if you use
the 3.5 mm plug audio cable.
6. Go to Page 15 for other detailed instructions.
NOTE:Your cable or antenna connection to your TV is not touched with this connection.
Leave your antenna cable to your TV as you normally would. No changes will be made
to your current antenna connections.
TV + DVD CONNECTIONS
Home Theater System + TV + DVD Player
CONNECT THE SPEAKERS AS SHOWN ON PAGE 8 (OR THE QUICK SETUP DIAGRAM SHEET).
RIGHT
LEFT
AUDIO
D
V
D
I
N
P
U
T
M
P
3
A
U
X
I
N
P
U
T
NOTE: On some TVs, this
jack is in the front.
NOTE: Some newer TV sets have several VIDEO
INPUT jacks. You may use one of these for your DVD
player and the others for connecting to the VIDEO OUT
jacks of the component. If your set is older and only has
a single VIDEO INPUT jack, you may buy a switch box
to change the video of DVD and Game.
11
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM12