Filter
Top Products
IB-HT377-WM-E-050405
1. Insert the stereo audio cables (included) into the DVD INPUT LEFT and RIGHT jacks on the
back of your HOME THEATER SYSTEM, and into the corresponding AUDIO output jacks
on your TV, this will allow your TV’s sound to play through your HOME THEATER
SYSTEM. You will hear sound from both the TV and your HOME THEATER, this is normal.
NOTE:On some TVs, you may have to activate the audio out jacks of your TV. See your
TV’s booklet.
2. Insert the AC power cord into an AC outlet.
3. Make sure the POWER switch on the back of the main set is at “ON” position. Next press
the ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to
switch the set on (or standby).
4. Press the SOURCE button till the DVD indicator lights.
NOTE:The factory’s default input source is DVD. When the set is turned to ON, the DVD
indicator will be on, press the SOURCE button to turn on the MP3 indicator if you use
the 3.5 mm plug audio cable.
5. Go to Page 15 for other detailed instructions.
NOTE:Your cable or antenna connection to your TV is not touched with this connection.
Leave your antenna cable to your TV as you normally would. No changes will be made
to your current antenna connections.
TV CONNECTIONS
Home Theater System + TV (if your TV has Audio Output jacks)
CONNECT THE SPEAKERS AS SHOWN ON PAGE 8 (OR THE QUICK SETUP DIAGRAM SHEET).
If you have a cable box or satellite receiver, you can connect the
receiver AUDIO OUTPUT directly to your DVD INPUT jack on the
back of the HOME THEATER SYSTEM.
NOTE: In order to have TV sound come through your home
theater system, your TV must have AUDIO OUTPUT jacks.
These jacks will always be in the rear of the TV (and not in
the front). If your TV does not have these output jacks, you
have to use a cable box or a satellite receiver to get the audio.
RIGHTLEFT
AUDIO
D
V
D
I
N
P
U
T
M
P
3
A
U
X
I
N
P
U
T
10
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM11