Filter
Top Products
IB-HT377-WM-E-050405
SPEAKER SYSTEM CONNECTIONS
Tips for connecting the speaker wires
Unwind and stretch out the speaker wires
attached with each speakers, then push the
set terminal tab on the back of the main set to
insert each wire. Make sure the wire is fully
inserted, but the insulation is not covering the
inserted part of the speaker wires.
SET TERMINAL
PUSH THE TAB OF TERMINAL.
STICK THE EXPOSED PART OF THE WIRE INTO
THE HOLE OF THE TERMINAL.
PUSH THE TERMINAL TO LOCK THE WIRE INSIDE
THE TERMINAL.
NOTE:
Be sure to match the speaker wire to the
appropriate terminal on the back of the main
set: grey to grey, and black to black. If the
wires are reversed, the sound will be distorted
and will lack some tones. Follow the color
codes of each terminals.
To avoid short-circuiting the speakers
•
Make sure the stripped end of each speaker
wire does not touch another set terminal or
the stripped end of another speaker wire.
•
Stripped wires are touching each other due
to excessive removal of insulation. Do not
allow the above to happen on your set.
•
Stripped speaker wire is touching another
set terminal. Make sure not even 1 strand
of wire touches the other wire!
Examples of poor connection of the
speaker wires
NOTE: If longer wires are needed, you may buy
any good quality speaker wire and splice the wires
yourself. Please make sure the wires are not
shorting to each other and observe the correct
color polarity.Many speaker wires have a dotted
line or solid line or raised rib on one side to identify
each side. Also make sure you use electrical tape
to cover your splices.
LOOSE STRANDS TOUCHING
(This will short out the sound)
WIRES SHORTED TO EACH OTHER
(This will short out the sound)
MAKE SURE ABOVE DOES NOT HAPPEN
9
MAKE SURE POWER IS OFF WHEN
DONG THE ABOVE
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM10