Filter
Top Products
E OPERATION
1. Plug the processor’s AC cord into the wall socket.
2. Turn ON your digital signal source. Whether it is CD,
DAT or Satellite is not important. The following should
occur in this particular sequence ¯
A. The two LED’s ddgignating Dig.ital and Analog power
will illuminate simultaneously. Ttiis is your assurance
that the individual power supplies are dperating and
stable.
B. After a period of 5 to 20 seconds the digital input
circuits will stabilize and the LED indicating the input
source frequency will be illuminated.
,,N, OT,E: The input source component must be turned
ON’ in order for the processor to indicate the input
source frequency.
CAUTION: Should you have any major deviation from
this sequence do not attempt to play the unit. Disconnect
it prior to powering up any other components and contact
your Krell dealer immediately.
3. Be sure that your preamplifier’s volume control is
completely turned to the OFF (lowest volume) position.
4. Turn ON your components, remembering that the last
component to be energized should be your amplifier. The
amplifier should only be turned ON after all other com-
po.nents in the system have been on for at least two (2)
minutes.
5. Switch the Input selector of your preamp to the po.si-
tion correlating to your chosen input connection for tlae
SBP-32X.
6. You may now start playing your DAT, CD or satellite.
7. Slowl), turn the volume control up to the lowest level
you can near. Check to see that both channels are work-
ing correctly before advancing the volume.
5