Filter
Top Products
CAUTION: Do not remove or bypass the ground pin on
the end of the AC cord. This may cause RFI (radio fre-
quency interference) to be induced into your playback
system.
4. Connect the Digital Output from a Krell CD Turntable
or any digital source to the Digital Input on the back
paneI of your processor..Ygur SBP-32X will accommo-
~late digital input from eitlaer the coaxial or fibre optic
outputs of any CD, DAT or Satellite broadcast source.
Note: Care should be taken in selecting the type of cable
used to link the digital source to your processor. If co-
axial cable is to be used it should be non-capacitive and
have a bandwidth in excess of 10MHz to prevent drop-
out errors.
Note
i
I.f a fibre optic cable is selected we strongly recom-
mencl that it be a-high quality quartz fibre cable. An
additional benefit ot
~
filSre optic cable is a reduction of
ground loop problems that often occur in audio systems.
5. Connect the appropriate OUTPUT of the SBP-32X to
the line level INPUTof your preamplifier’ The red
banded connector indicates the right channel and the
white indicates the left.
The SBP-32X is equipped with two output configura-
tions: Single-ended via RCA connectors and Balanced
via XLR connectors. If your preamplifier has high level
balanced inputs we recommend the balanced outputs of
the processor be used. There are considerable sonic
benefits associated with balanced operation.
NOTE: both outputs can be used to simultaneously feed
two different systems.
4