Filter
Top Products
C. FCC COMPLIANCE STATEMENT
WARNING: Changes or modifications to this unit not
expressly_ approved by t_h,e party responsible for compli-
ance could void the user s authority to operate the equip-
ment.
Note: This equipment has been tested and found to com-
ply with the fimits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable .protection against harmful interfer-
ence in a residential-installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instructions
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of-the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult your dealer or an experienced radio~V
technician for help.
The user may find the following booklet prepared by the
Federal Communications Commission helpful:
"Television Interference Handbook"
This booklet is available from the U.S. Government
Printing Office, Washington DC 20402.
Stock No. 004-000-00450-7
WARNING: The use of non-shielded analog output
cables and non-shielded digital input’ cables if coax is
used for the digital input (fibre optic interconnect need
not be shielded) will invalidate the FCC Certification of
this device and may cause interference levels which
exceed the limits established by the FCC for this type of
device.
2