Filter
Top Products
CAUTION: FAILURE TO REMOVE TRANSPORT
SCREWS BEFORE OPERATION COULD RESULT IN
DAMAGE TO THE TRANSPORT.
CAUTION: FAILURE TO REMOVE THE PROTEC-
TIVE HUB BEFORE THE UNIT IS PLUGGED INTO
THE AC RECEPTACLE OR BEFORE OPERATION
COULD RESULT IN,DAMAGE TO THE TRANS-
PORT. ~
D. DUST COVER INSTALLATION
1. Standard Version Smoked Dust Cover:
Remove the dust cover, in its protective sleeve, from the
shipping foam. To prevent scratching leave the protective
sleeve on the dust cover until the cover mounting is
complet.e. There are two pairs of screws w.ith wasOer-type
receptacles attached to the back panel of the unit tor
mounting the dust cover. Center the hinge pins on the
dust cover over the two pairs of screws. Carefully slide
the hinges into the slots Formed by the washers. Push the
cover down evenly on both sides until it is fully seated.
Finally, remove the protective sleeve.
2. Custom Version Clear Lucite Dust Cover:
Remove the dust cover from the protective foam and its
protective sleeve. There are two pairs of screws with
washer-type hinge receptacles on the back. of the un!t.
Remove the four screwg from the unit ancl take off the
black hinge receptacles. Carefully place the lucite dust
cover such that the circular milled-out portion,is centered
over the transport. Align the slots in the cover s hinge
blocks with ttie holes in the back of the chassis. Thread
the four screws into the chassis through the hinge blocks.
Tighten down lightly and adjust the cover so it is ce.n-
tered on the unit. Once the cover is aligned tighten clown
the supporting screws.
NOTE: The clear lucite cover must be lowered manually,
as it is very heavy and does not have a damping
mechanism.