Filter
Top Products
INSTALLATION OF THE CUSTOM ACRYLIC TOPCOVER FOR MD-2
O MD-~
KRELL DIGITAL INC,
2
l
T-BLOW
l. To remove molded cover, slide the cover assembly upward until the hinges are cleared from both sets of
screws and washers.
2. Be sure to save all the screws and washers after disassembly.
-CUSTOM ACRYLIC COVE~
~-2
KRE/& DIGITAL/NC
2
I FAST-BLOw
1,
Remove the four original hinge retaining screws from the back of the unit.
2.
Remove the three washers from each screw.
3,
Gent/y place acrylic cover on the chassis top, center the hinges to match the holes in the chassis.
4.
Insert the four screws without washers into the hinge and fasten Ioosely.
5.
Center the cover with the chassis and secure hinge block screws.
MARCH 1, 1991