Filter
Top Products
UNPACKING AND PLACEMENT
1. Once the box is opened and top layer of foam removed, the following items
will be visible:
1 KPS-20
1 KPS-20 Remote Control
1
KPS-20 Custom 5 point CD clamp (packed beneath the KPS-20)
1
AC power cord
1
T-10 torx driver
1
Packet containing the Owner’s Reference and Warranty
Registration Card
NOTE: If any of these items are not included, please contact your authorized
dealer immediately for assistance.
2. Carefully remove the unit and accessories from the box. Remove the
protective plastic wrap from the unit.
NOTE: Save all packing materials. If you must ship your KPS-20 in the future,
repack the unit in its original packaging to prevent transit damage. KRELL is not
responsible for damage incurred during the shipment of goods without factory
approved packing material.
PLACEMENT
Before you install the KRELL PLAYBACK SYSTEM-20 into your system, we
recommend that you follow these guidelines in choosing the location. This will
facilitate a clean, trouble-free installation. The KPS-20 does not require any type
of special rack or cabinet for installation. Dimensions are described on page 27.
1. Place the unit on a firm level surface away from excessive heat, humidity or
moisture. Make sure there is enough room at the top for a compact disc to
be placed within the chassis. Approximately ten inches is necessary.
2. Although well shielded, the KPS-20 should not be place~d in close proximity
to hum-sensitive components such as preamp phono stages or turntables.
The power supply may create interference and induce hum.
3. The KPS-20 incorporates an advanced suspension system and does not
require additional mass coupling or isolation. You may experiment with feet or
cones as long as they don’t permanently affix to the chassis. Any unauthorized
modifications to the electronics or chassis will void the warranty.
4