Filter
Top Products
HOW TO CONNECT ST CABLES
1. Remove the plastic cover from the outside of the ST transmitter (located on
transport) and receiver (located on processor).
2. Remove the plastic cap from both ends of the ST cable.
3. Locate the key tab on the end of the ST cable.
4. Locate the slot on the top of the ST receptacle.
5. Slide the cable connector into the ST receptacle, with the key guided into the
designated slot.
6. Gently push the connector into place, depress the internal spring, and twist
the outer collar clockwise to secure the outer ring to the posts on the chassis
connector.
7. Use the same procedure for the processor input.
ST/TIME SYNC OUTPUT
The ST connector labeled ST/Time Sync can be switched between Time
Sync and a normal data output. The KPS-20t comes with this output Set for
Time Sync. Follow the procedure below to switch it to a data output:
1. Turn the power amplifier Off and the preamplifier to Mute or Standby
2. Turn the two thumbscrews counterclockwise until they release from the
chassis
3.
Hold the thumbscrews and pull the panel/board assembly straight out of the
unit
4. On the circuit board there is a switch labeled Time Sync on one side, Data
on the other
5. Move the switch to the Data
6. Slide the board back into the chassis
7. Firmly press the board into its mating connector
8.
Turn the thumbscrews clockwise until they are tight
17