Filter
Top Products
Remote Control Description
See Figure 3 on page 11
Battery
Installation
and
Removal
The KAV-250cd/2 remote control uses two AAA-size batteries, which
are included with the shipment.
1. Remove the backplate, by sliding it off the remote control.
2. Install the batteries, following the battery position diagram on
the plastic battery receptacle.
3. Replace the backplate.
The remote control is ready for operation.
Notes Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time.
Battery leakage can damage the remote control.
Remote Control
Functions
POWER
The KAV-250cd/2 remote control provides power, compact disc
transport, and compact disc programming functions. A description of
the remote control keys that are used with the KAV-250cd/2 follows.
22 Pwr (Power) Key
Use this key to switch the KAV-250cd/2 between the stand-by and
the operational modes.
COMPACT
DISC
TRANSPORT
FUNCTIONS
23 CD Key
Use this key to activate the compact disc and power functions on the
KAV-250cd/2 remote control.
24 Display Key
Use this key to cycle the front panel display between the elapsed
time of the current track, the elapsed time on the entire compact disc,
and the remaining time on the entire compact disc. See also How to
Program a Track Sequence, on page 16.
12 Krell KAV-250cd/2