Filter
Top Products
- 3 -
Do not place any open sources of re, like candles, on the •
device.
When a storm and/or thunderstorm with the risk of lightening
•
threatens please disconnect the device from the mains power.
Risk of personal injury!
Keep the power cord and device away from children. •
Children frequently underestimate the dangers of electrical
appliances.
Ensure a safe location for the device.
•
Do not operate the device if it has sustained a fall or is •
damaged. Arrange for the device to be checked and/or
repaired by qualied technicians.
Batteries should not be allowed to fall into the hands of
•
children. Children can put batteries into their mouths and
swallow them. If a battery is swallowed medical assistance
must be sought immediately.
Danger of eye injuries!
Never look directly into an open CD tray The invisible laser •
beam could damage your eyes.
CAUTION!
Information on surge voltage (EFT / rapid electrical
transition process) and Electrostatic discharge:
In the case of a misfunction due to rapid electrical transition
(surge voltage) or electrostatic discharge the product must be
reset (it may be necessary to disconnect the power source and
then reconnect it) to restore normal operation.
Note: A case of electrostatic discharge occurs if one walks
with plastic-soled shoes over a carpet that also contains ele-
ments of plastic. Through the friction of the shoe soles on the
carpet a charge is created in the body which discharges itself
as soon as one touches an electricity conducting object, such
as for example a door knob or the bodywork of a motor vehicle.
Thereby it is sucient to approach the conductor to within only
a few cm. Direct contact is not required to eect a discharge.
The charge can also reduce itself over an electrical arc. A
discharge is thus also possible through plastic housing compo-
nents.
Note: This device is equipped with non-slip rubber feet.
As upper surfaces can comprise of various materials and are
treated with various cleaning materials, it cannot be completely
excluded that some of these materials contain components that
could attack and soften the rubber feet. If possible place an
anti-slip material under the feet of the device.
Observe copyright laws
When recording CDs, cassettes or radio transmissions make
sure you observe the copyright regulations of the country in
which the device is to be used.
Setting the device
Remove the micro system and accessories from the packing. >
Remove all transportation fasteners and tapes/foils.
>
Place the micro system on an even, level surface. Place the
>
micro system in such a position that the CD tray cover q
can open fully.
Place the speakers to the right and left of the micro system.
>
The operational controls
qCD compartment
w OPEN / CLOSE - CD tray open/close
e Display
r BAND - Radio band switching
t FIND/ESP/MONO/ST. - Search function during MP3
operation
On/O switch for the ESP system
USW mono/stereo switching
y
VOLUME: - Volume control +/—
u PLAY/PAUSE4; - CD playback start/stop
i STOP < - End CD playback
o Cassette tray cover
aProtective ap for the cassette player keys
s<
- Stop cassette playback
d - Cassette playback end
open cassette tray
f 8 - Cassette wind forward
g7 - Cassette wind backward
h 4 - Start cassette playback
j = - Start cassette record
k Battery backup compartment (Underneath the device)
l PHONES - Headphones socket
; SKIP/TUNING 9 - CD title skip backwards
Station search down
2) PRESET/FOLDER 3 - switch to the previous MP3 folder
and/or radio station memory spot
2!
4PRESET/FOLDER - switch to the next MP3 folder
and/or radio station memory spot
2@
SKIP/TUNING : - CD title skip forwards,
station search up
2# Infrared sensor for the remote control signal
2$ FUNCTION - Select programme source
2% STANDBY indicator - lights up when ready for operation
2^ : - to switch the device on and o
2& Speaker
2* Connection socket for FM (USW) antenna (75 Ohm)
2( Connection for AM (MW) antenna
3) Speaker connection LEFT +
3! Speaker connection LEFT —
3@ Speaker connection RIGHT —
3# Speaker connection RIGHT +
3$ Medium wave (AM) antenna
3% Power cord
3^ BEAT CUT switch - for noise suppression during
recording of MW stations
3& Power switch (ON/OFF)
3* VOLUME + - Volume increase
3( Number buttons for number inputs
4) SLEEP - activate the sleep timer
4! TIMER - switches the timer function on/o
4@ MEM/C-ADJ. - for memory storage of radio stations
and CD programmes
4#
< - CD playback end
4$ : - CD title skip forwards
Station search up
4% REPEAT - controls the repeat mode
4^ FIND/ESP/MONO/ST. - Search function during MP3
operation
On/O switch for the ESP system
USW mono/stereo switching
4& FUNCTION - Select programme source
4* MUTE - switches the mute function on/o
4( STANDBY - to switch the device on and o
5) PRESET/FOL UP - switch to the previous MP3 folder and/or
radio station memory spot
5! BAND - radio band switching
5@ PRESET/FOL DN - switch to the next MP3 folder and/or
radio station memory spot