Filter
Top Products
8
Note: Some commands are read or write only and
some are both. For example “Mute All” is a write only
command and “Version” is a read only command.
Supported Command Messages
Function Command Message
Version (vr?) Version Number
Reset (rx) “Resetting...”
Channel On (#on) “Zone # on”
Channel Off (#of) “Zone # off“
Mute (#mu) “Zone # muted”
Un-mute (#um) “Zone # unmuted”
Mute All (amu) "All channels muted"
Un-mute All (aum) "All channels un-muted"
Volume Request (#vl?) "Zone # volume level = $$"
Volume Set (#vl$$) "Zone # volume level set"
Volume All (avl$$) "All volume levels
successfully changed"
Input Set (#sl$) "Zone # input set"
Input Request (#sl?) "Zone # is currently using
input channel $”
Input Select All (asl$) "All zones set to source $"
All Channels Off (aof) "All zones turned off"
All Channels On (aon) “All zones turned on”
All Channels Vol up (avlu) “All zones volume levels
increased”
All Channels Vol dn (avld) “All zones volume levels
decreased”
Channel Vol up (#vlu) “Zone # volume increased”
Channel Vol down (#vld) “Zone # volume decreased”
Bass adjustment (#b$) “Bass successfully set to $”
Treble adjustment (#t$) “Treble successfully set to $”
Message Examples e will use the example commands from
before, and show what the responses are.
Function Command Response Reply
On/Off (1on) Zone 1 on
Select Input (1sl3) Zone 1 input 3 set
Set Volume (1vl50) Zone 1 volume level = 50
Set Bass (1baf) Zone 1 Bass successfully set
to 15
Set Treble (2ta) Zone 2 Treble successfully
set to 10
Increase Volume (2vlu) Zone 2 volume increased
BIB AND BIX INPUT WALL PLATES
The BIX is an input module for sources in distant rooms or
locations. To the zone it’s in, it would be ‘Local’. For this
reason we identify it as such, think of it as stage left for
custom installation. It’s a feature unique to Q450. It
provides a differential balanced input to allow
transmission of an analog signal over long distances
without generating noise or signal loss due to conductor
impedance. BIX is an acronym for Balanced Input
eXtender. Enough with the fancy talk. It makes your iPod
sound good even though it’s far from the Q450 amp. It’s a
clever solution to a perennial problem faced in distributed
audio systems. We just decided that it’s too important to
not have integrated into the system.
You can connect any audio source as long as your
connecting cable has a 3.5mm (1/8th”) termination or an
adaptor on the other end. This includes, but isn’t limited
to, CD players, media servers, tuners, feature phones,
smartphones, iPods, laptops, desktop computers, tablets,
mp3 players, Bluetooth receivers, etc.
BIB INPUT PLATE WITH BLUETOOTH
The BIB is almost identical to the BIX above with added
Bluetooth capability. Bluetooth is normally on and
connected. When a jack is plugged into the AUDIO IN port
Bluetooth is disabled and the signal from the 3.5mm jack is
sent on the balanced line to the Q450 amplifier. BIB is an
acronym for Balanced Input Bluetooth.