Filter
Top Products
6
This configuration shows a laptop connected
to the RS232 port to control the Q450rs.
A BIX balanced input wall plate is shown
connected to input #1. The speakers are
shown connected to the Q450rs amp #1 outputs.
Before trim out (or final installation) always double-
check the wires for continuity and short circuits as
problems can arise such as a tradesperson driving a
screw through the wire.
We suggest using a cat5 tester and investing in top
quality crimp tools as second-rate or poor crimping
is the number one source of installation problems.
Typical Installation
with four zones, each
connected to a pair
of speakers.
Zone 1 also has a
BIB balanced
input plate.
Zone 2: Den
Zone 3:
Bedroom
Zone 1: Hot tub
Speaker
Selecting input 1 from any
zone will allow that zone to
monitor the hot tub input source
Q450rs TYPICAL SYSTEM LAYOUT
Zone 4:
Kitchen