Filter
Top Products
13
SS Component Systems
Installation
When mounting to a door panel it is best to get the tweeter as high up on the door as
possible and as far forward as possible without interference from the dashboard. Be sure
the chosen place is flat and space behind the door panel allows the use of the Tweeter
Mounting Nut.
Follow the same rules if mounting to a rear deck, side panel or any other
custom location. Be sure you have chosen a flat location with plenty of
clearance behind it for the necessary wiring and mounting hardware.
After checking for clearance, cut a 1-15/16” (4.9 cm) hole in the desired mounting
location. It may be necessary to cut a 2-1/2” (6.4 cm) clearance hole in any sheet metal
or panel behind your chosen mounting panel to allow clearance for the Tweeter
Mounting Nut.
See the diagrams on this page
for more details.
Door Body
weeter
Tweeter Mounting Nut
15 ° Angle Mounting Rin
(Optional)
1-15/16" Hole
(4.9 cm)
Clearance Hole 2-1/2"
(6.4 cm)
Angle Mount Back Ring
(Optional)
Door Panel
Side Panel or Rear Deck
Place tweeter into cutout
1-15/16" hole
(4.9 cm)
Secure with tweeter
mount nut
Sheet Metal, Car Body, Etc.
Clearance
Hole 2-1/2"
(6.4 cm)
Angle Mount Back Ring
(Optional)
Angle Mount Ring
(Optional)