Filter
Top Products
10
SS Component Systems
Installation
COAXIAL MOUNT WITHOUT GRILL
Prepare The Midrange
Remove any posts or
plugs in the Midrange. It
should look like the pic
shown here.
Next you will need to
remove the Driver Boot
from the back of the
Midrange. It is a friction
fit, simply pull it straight
off the back.
Prepare The Tweeter
You will need to have the Tweeter,
Tweeter Mounting Post and your choice of
Tweeter Mounting Ring (Blue or Black).
Insert the Tweeter into Tweeter Mounting
Post and tighten by turning clock-wise.
Next attach the
Tweeter Mount Ring
and tighten by turn-
ing clock-wise.
You should now have
a tweeter assembly that
looks like this to insert
into your Midrange.
Insert the tweeter
assembly into the
midrange while feeding
the wire through the
Midrange’s motor as
pictured. Tighten by
turning clock-wise.
Lay the tweeter wire
in the machined
groove on the motor
back plate and press
Midrange Driver Boot
into place. Several
inches of the tweeter
wire will be exposed
to permit wring.
You should now
have an assembly
that looks like this.
Repeat this
process for the second Tweeter and
Midrange.
The SS System is now ready to mount.