Filter
Top Products
+
-
GROUND
REMOTE
TURN-ON
BATTERY
+12V
FUSE
18"
or less
+
-
+
-
SIGNAL IN AMP 1
SIGNAL IN AMP 2
When AMP 1 is driving speakers that do not require a crossover,
the crossover switch may be set to the OFF position. This will allow the
speakers to play full range.
OR...
If AMP 1 is driving speakers that do require a crossover, set the switch
to HI PASS. This will allow only high frequencies to pass through the
amplifier to the speakers.
AND...
If AMP 2 is used to drive subwoofers, set the switch to LO PASS.
This will allow only low frequencies to pass through the amplifier
to the woofers.
To Woofer
To Left Speaker
-
-
To Right Speaker
-
System Diagrams
KX200.4 3 Channel
Stereo Mode
KX100.2 & KX200.4 Technical Manual
Version 2.0
Page 15