Filter
Top Products
3
Preparations
XD-DV series (EN/K,M,T,X,Y)
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit
was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can
file a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Keep this manual handy for future reference.
Accessories
Please confirm that the following accessories are present.
FM indoor antenna (1) Loop antenna (1)
Remote control unit (1) Batteries (R6/AA) (2)
*AC plug adaptor (1)
* Use to adapt the plug on the
power cord to the shape of
the wall outlet.
(Accessory only for regions
where use is necessary.)
/
Video cord (1)
System Front speakers Surround Speakers and accessories
XD-DV90 LS-N90V (Left speaker and right speaker) CRS-N90V (Center speaker × 1, surround speakers × 2,
speaker cords× 3, speaker stabilizer× 12)
XD-DV80 LS-N70V (Left speaker and right speaker) CRS-N90V (Center speaker × 1, surround speakers × 2,
speaker cords× 3, speaker stabilizer× 12)
XD-DV70 LS-N90V (Left speaker and right speaker) –
XD-DV60 LS-N70V (Left speaker and right speaker) –
XD-DV50 LS-N50V (Left speaker and right speaker) –
XD-A850DV LS-N50V (Left speaker and right speaker) –
The space between radio channels has been set to the one
that prevails in the area to which the system is shipped.
However, if the current channel space setting does not
match the setting in the area where the system is to be used,
for instance when you move from area 1 or area 2 shown in
the following table or vice versa, proper reception of AM/FM
broadcasts cannot be expected. In this case, change the
channel space setting in accordance with your area by refer-
ring to the following table.
(Except for the U.S.A., Canada, U.K., Europe and Australia)
CHANNEL
SPACE frequency
Area
1
2
USA, Canada and South
American countries
Other countries
FM : 100 kHz
AM: 10 kHz
FM : 50 kHz
AM: 9 kHz
Setting the CHANNEL SPACE
1 Set the POWER key to standby (power off) mode.
2 Press and hold the STOP (
77
77
7) key for more than 2 seconds.
Each press for more than 2 seconds switches the modes
as follows.
1 “FM100/AM10 kHz” STEP
2 “FM 50 /AM 9 kHz” STEP
STOP
7
CHANNEL SPACE setting
Accessories packed with the main unit
Speaker model names and accessories packed with the speakers