Kenwood XD-8050 Stereo System User Manual


 
XD-8550/XD-6000 (En/T)
55
Preparation section Basic section Application section Knowledge sections
CCRS
REC / ARM
During recording: X-H5
3
2
1
Press so that the “PGM” indicator goes off.
Giving preference to the tape length over the title sequence
(Time edit recording)
Recording preparations are required.
¤ ¤
¤ ¤
¤
For the reverse mode, select “
” ,“
[
”(two-way recording).
When equalizer, SRS 3D or another effect is applied
to the sound, the sound with the applied effect can
be recorded.
OP
When the tape recording time is specified, recording is executed with changing the title sequence so that no title will be
interrupted when the tape direction is changed at the end of one side.
Convenient CD recording
PGM
MEMO
EDIT RDS EON TA
N
AUTO
TUNED
DISC ALL
STEREO
D_
*
PGM
MEMO
EDIT RDS EON TA NE
W
AUTO
TUNED
DISC ALL
STEREO
CD
*
MAX
SLEEP O.T.T.
Should be OFF.
Start edit recording.
4
Light the “EDIT” indicator.
Enter the disc and tape conditions.
Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
÷The tape and CD stop automatically when recording has completed.
P.MODE
EDIT
PTY
SEARCH
123
456
789
0 +10
O p π
CCRS
Depending on the combination of conditions from CD contents (number of titles and length of the titles) and tape recording time, interruption
of a title may not be avoidable. In such a case, the respective title will not be recorded.
Note
Note
÷When pressing the EDIT key, “SPACE” indicator also lights up with
“EDIT” indicator. To cancel the auto-space function, press the SPACE
key.
‡q
If more than 8 seconds have elapsed,
select the mode again.
÷The recording time is 99 minutes maximum.
÷Up to 32 tracks can be edited.
÷CD tracks will be edited automatically onto tape sides A and B. After
editing, the “EDIT” indicator stops blinking and starts to light steadily.
46-, 54-, 60- or 90-minute tapes can be selected simply by pressing the
TIME key for the required number of times. (The recording time can be
adjusted in 1-minute steps with the 4 and ¢ keys.)
After entry, press the EDIT key then proceed to step 4.
PGM
MEMO
EDIT RDS EON TA NEWS INFO. TP PTY TOTAL SPACE
AUTO
TUNED
DISC ALL
STEREO
kHz
MHz
D1*)1*C--: -
PROG.
PGM MEMO EDIT RDS TA NEWS INFO. TP PTY EON SLEEP O.T.T.ECHO
SPACE TOTAL ST.
DISC ALL AUTO
TUNED
P.B.C.
kHz
MANUAL
N.B.
MHz12
EQ. ON MUTE
CD****C---;
Lights
For XD-8550
For XD-6000
1Enter the disc No. (DP-MH5 only)
2Press the EDIT key.
(DP-MH5 only)
DISC SKIP
Go to step 2 within
8 seconds.
Go to step 3 within 8 seconds.
3Enter the recording length of the tape.
Blinks Lights
Blinks
Character information indicators cannot be displayed while
the spectrum analyzer display is used. Switch to the dual
display or character display mode to see the information.
Note
Note
Wait until the “EDIT” indicator stops
blinking, and then press the CCRS key.