Filter
Top Products
XD-SERIES (EN/M,T)
35
Basic section
Copying tape
(Tape dubbing)
1 Select the “TAPE” input.
2 Press the stop key.
3 Select “
” (double-side recording) or “ ”
(one-side recording).
‹
4 Select “Tape Dubbing”.
The contents of the tape in deck A can be copied onto the tape in deck B.
÷ Dubbing ends automatically when the side(s) to be
dubbed has been completed.
Playing tape
Recording tape
Load tapes in the decks.
+Scrolled display (Tape Dubbing)
5 Use the same tape transport directions.
6 Start dubbing.
(1) Select the transport direction of deck A.
(2) Select the transport direction of deck B.
÷ When recording is started, the tape will be transported
in the direction selected in this step.
(
>
:side A,
<
: side B)
+Scrolled display
(Deck A Play Direction)
+Scrolled display
(Deck B Record Direction)
+Scrolled display (Press 'ENTER' to Start)
Tiape Dubb
Lights
PTress 'EN
INPUT
REV. MODE
ENTER
To stop dubbing
÷ The deck B will stop after creating a non-recorded
portion of about 4 sec, and then the deck A will stop.
÷ Dubbing can also be stopped by pressing the stop (&)
key of the cassette deck unit. Note that the non-
recorded space is not created in this case.
The DOLBY NR or TAPE EQ. key is ineffective
during dubbing.
The tape recorded on deck B assumes the same
Dolby NR condition as the tape played on deck A.
REC/ARM
MENU
SELECT
M
U
L
T
I
C
O
N
T
R
O
L
&
¡
#
¡
#
Let's record
The following items can be selected by turning
the MULTI CONTROL jog dial.
“Recording Options”
“Tape Dubbing”
“Audio Options”
“Clock Options”
“Surround Setup”
(Except for XD-7...series)
SELECT
M
U
L
T
I
C
O
N
T
R
O
L
SELECT
M
U
L
T
I
C
O
N
T
R
O
L
AA
Daeck A Pl
A deck >
Dceck B Re
B deck >
XD-6...series, XD-8...series :
÷ “Tape Dubbing” cannot be selected during DSP or
surround playback. In these modes, select another
equalizer pattern and retry.
E