Kenwood XD-772S Stereo System User Manual


 
XD-SERIES (EN/M,T)
10
Preparation section
Surround speakers system (supplied)
123
Twist
4
Twist
Speaker Unit
Main Unit
1234
Hanging on a wall
The speakers can be hung on a wall by using the wall
hanging holes on the back of the speaker.When hang-
ing the speakers, select a rigid and hard place on the
wall which can withstand the weight of the speakers.
1. Install a screw with sufficient strength on the wall.
When screwing in, leave the head and upper stem of
the screw projected by 7 to 9 mm from the wall
surface.
2. Hang the speaker by inserting the screw into the wall
hanging hole on the upper rear side of the speaker.
Check that the speaker are firmly mounted.
Recommended speaker installation
It is recommended that the surround speakers are in-
stalled straight to the left and right of the listening
position or slightly behind, at a height of about 1
meter higher than the listener’s ears. Each surround
speaker should be installed so that the longer sides
are horizontal.
How to use the speaker stabilizer (cushions)
When the surround speaker system installation is un-
stable due to the floor condition, apply the provided sta-
bilizer (cushions) on four positions on the bottom of
each speaker.
Connection of the surround speakers
(XD-6...series, XD-8...series)
CAUTION
Note on Connection
Connect the components as shown in the diagram.Only plug the power cord into a power outlet once connections
are completed. The rear panel configuration is variable depending on the models (countries or area).
Center speaker
Surround speaker Surround speaker
CENTER SPEAKER(
6-16
)
SURROUND SPEAKERS
(
12-16
)
+
-
L
R
−+
−+
−+
· ª
· ª · ª
System connection
Before connecting the surround speakers system, be also sure to read “Surround function” and “Surround setting”.
TY
÷ Before installation, check the wall or ceiling well to
confirm that it is strong enough to withstand the
weight of the speaker. KENWOOD cannot assume the
responsibility against accidents caused by the drop of
speaker due to insufficient mounting strength or to any
defect in installation.
÷ The wall hanging screw is not provided. Please prepare
a screw that can assure enough mounting strength
according to the material and thickness (structure) of
the wall where the speaker is to be hung.
÷ If the material or thickness of a wall or ceiling cannot be
confirmed, consult a professional specialized in
installation.