Filter
Top Products
14
SCAN
If the Scan function is programmed, zones or channels can be scanned by
pressing the key programmed as Scan. Scan can be used as either Single
Scan, Multi Scan, or List Scan.
• Single Scan monitors only the channels of the currently selected zone, which have
been added to the scanning sequence. If set up to scan Priority channels, the Priority
channels will be scanned even if they are not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been added to the
scanning sequence.
• List Scan monitors all channels within the specified range of zones, which have been
added to the scanning sequence. If set up to scan Priority channels, the Priority
channels will be scanned even if they are not within any of the zones in the list.
To activate Scan, press the key programmed as Scan.
• The icon and “SCAN” or the revert zone and channel/ group ID number appear on
the display.
• The zone add indicator (TK-X180/ TK-X180H:
/ TK-X182/ TK-X182H:
) will appear on the display when the selected zone is added to the
scan sequence. The channel/ group ID add indicator (TK-X180/ TK-X180H:
/ TK-X182/ TK-X182H: ) will appear on the display
when the selected channel/ group ID is added to the scan sequence.
• When a call is received, scanning stops and the zone and channel/ group ID digits
appear. Press the PTT switch and speak into the microphone to respond to the call.
The transceiver will continue scanning after a predetermined time delay if the PTT
switch is released and no further signal is received.
To stop scanning, press the Scan key again.
ADD TO SCAN/ DELETE FROM SCAN
Press and hold the key programmed as Scan Delete/Add, to add or remove
each zone or group ID/ channel to or from the scan sequence.
• The zone add indicator (TK-X180/ TK-X180H: / TK-X182/ TK-X182H:
) will appear on the display when the selected zone is added to the
scan sequence.
• The channel/ group ID add indicator (TK-X180/ TK-X180H: /
TK-X182/ TK-X182H:
) will appear on the display when the selected
channel/ group ID is added to the scan sequence.