Filter
Top Products
SONY MZ-B3 (E) 3-798-610-22(1)
Additional information
35
Error messages
If the following error messages flash in the display window, check the chart below.
Error message
BLANKDISC
BUSY
CANNOT
DISC ERR
DISC FULL
Hi DC in
HOLD
LOW BATT
NO DISC
PB DISC
PROTECTED
Meaning/Remedy
•An MD with no recording on it is inserted.
b
Insert a recorded MD.
•You tried to operate the recorder while it was accessing the
recorded data.
b
Wait until the message goes out (in rare cases, it may take
2–3 minutes).
•You tried to erase a track mark while playing the MD or at the
beginning of the first track.
•You tried to erase a track mark to combine tracks the recorder
cannot combine. (This is caused by system limitation.)
•The recorder cannot read the disc (it's scratched or dirty).
b
Reinsert or replace the disc.
•There is no more space on the disc (less than 24 seconds
available in monaural).
b
Replace the disc.
•Power supply is too high (The recommended AC power
adaptor is not used).
b
Use the recommended AC power adaptor.
•The recorder is locked.
b
Slide HOLD against the allow to unlock the recorder
(page 21).
•Batteries are weak.
b
Replace the dry batteries or charge the rechargeable
battery (page 6 or 27).
•You tried to play or record with no disc in the recorder.
b
Insert an MD.
•You tried to record or edit on a premastered MD (PB means
playback.)
b
Insert a recordable MD.
•You tried to record or edit on a MD with the tab in the record-
protect position.
b
Slide the tab back (page 15).
Continue to next page m