Open as PDF
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output channels and
the receiver, you can enjoy surround sound playback.
Connecting a DVD player which can decode the surround signal itself is
• Connect your DVD player to the DVD/6CH jacks of the receiver.
• Turn on all other components that will be used.
• Complete “Preparing for surround sound”. *
Press “DVD/6CH” as the input source.
• If speaker system B is on when “DVD/6CH” is selected as the input
source, it switches off and speaker system A turns on automatically.
Select "6CH INPUT" by pressing the INPUT MODE key.
Start playback of the DVD software.
Adjust the volume.
• It is not possible to adjust the volume level or sound quality (SET
UP, SOUND, LISTEN MODE, ACTIVE EQ and TONE key will not
be functional) of the channels separately when the receiver is in
the 6CH INPUT mode. Adjust the volume with the controls of the
For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofer’s own volume control.
SOUND LISTEN MODE
@ / #)
Adjusting the sound
You can make further adjustments to the sound while listening to
playback in the surround mode.
1 For the remote control, press and hold the TUNER key for more
than 3 seconds to switch to receiver mode.
2 Press the SOUND key and then use the ∧/∨ keys or @/# keys
until the desired item appears in the display.
Each time you press the ∧/∨ keys or @/# keys, the menu
changes as follows:
Note that some items are not displayed in certain modes.
1 CNTR (Center speaker level adjustment)*
2 SR (Right surround speaker level adjustment)*
3 SB (Surround back speaker level adjustment)*
4 SL (Left surround speaker level adjustment)*
5 SUBW (Subwoofer level adjustment)*
6 INPUT (Input level adjustment - analog mode only) )
(Midnight mode ON/OFF - Dolby Digital mode only)
8 PANORAMA (Panorama mode
9 DIMENSION (Dimension adjustment)**
0 CENTER WIDTH (Center width adjustment)**
- CENTER FOCUS (Center focus adjustment)***
= CSII DLY (Rear speaker delay adjustment)***
~ CSII GAIN (Input gain adjustment)***
! TruBass (TruBass adjustment)***
* The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value when
the power is turned on/off or when the input selection is changed.
** Pro Logic II Music mode only.
*** CS II mode only.
3 Use the MULTI CONTROL knob or Multi (%/ﬁ) keys to adjust the
setting as desired.
• The adjustment item is displayed for approximately 8 seconds.