Filter
Top Products
15
Preparations
Preparing for surround sound
Speaker settings
1 Surround speakers are connected to the re-
ceiver.
2 No surround speakers are connected to the
receiver.
9
Turn on the power to this receiver by pressing POWER and
ON/STANDBY key.
Select a speaker system.
1
2
3
1
2
1 A subwoofer is connected to the receiver.
2 No subwoofer is connected to the receiver.
• When the setting "SUBW NO" is selected, the front speakers
automatically are set to "Large" and the procedure skips to step 5.
3
• The front speakers setting indication (FRNT) appears.
4
1 (normal) Average size front speakers are
connected to the receiver.
2 (large) Large front speakers are con-
nected to the receiver.
5
• The center speaker setting indication (CNTR) appears.
Adjust the volume levels for the speakers.
The channel indication blinks while the test tone is being output.
Sit in your normal listening position and listen to the test tone. Adjust the
volume levels for the speakers until all speakers seem to be equally loud.
1
= = = = = =
• If you change the volume level settings for the speakers while listening
to music, the settings referred to on this page are also changed.
¶
• If the speaker setting selects are changed, the speaker level settings
are reset.
2
• The receiver enters the mode for inputting the distance to the
speakers.
To enable you to obtain optimum enjoyment from the receiver’s listening
modes, make sure to complete the speaker settings (subwoofer, front,
center, and surround speakers) as described below.
1 A center speaker is connected to the
receiver.
2 No center speaker is connected to the
receiver.
7
• The surround speaker setting indication (SURR) appears.
8
1 (large) Large surround speakers are con-
nected to the receiver.
2 (normal) Average size surround speakers are
connected to the receiver.
3 No surround speakers are connected
to the receiver.
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND
AUTO
LFE
C
S
RSLS
TI.VOLB
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
RL
SP A
STEREO
STEREO
R
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND
AUTO
LFE
C
S
RSLS
TI.VOLB
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
L
SP A
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND
AUTO
LFE
C
S
RSLS
TI.VOLB
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
RL
SP A
STEREO
6
1 (large) A large center speaker is connected to
the receiver.
2 (normal) An average size center speaker is con-
nected to the receiver.
3 No center speaker is connected to the
receiver.
• The receiver enters the speaker volume level adjustment mode.
• In steps 3 and 4, indications appear only for the selected channels
of the speakers that require adjusting.
MULTI
CONTROL
SET UP
MULTI CONTROL
KRF-V6030D/
V5030D/
V4530D
SET UP
RC-R0610
SET UP
RC-R0510
MULTI
CONTROL
POWER
ON/STANDBY