Open as PDF
— 27 —— 27 —
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
Firewall or metal support
■ Installing in Japanese-Made Cars
T: Toyota cars
N: Nissan cars
Accessory3...for Nissan car
Accessory4 ...for Toyota car
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations
1 Refer to the section “Removing the hard rubber frame” (page
28) and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the
Bend the tabs of the
with a screwdriver or
similar utensil and
attach it in place.
■ Screwing the Faceplate on the Unit
Never insert the taptite screw (ø4 × 16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
If you want to fasten the
faceplate to the main
unit so that it does not
fall off, screw in the
provided screw (ø4 × 16
mm) in the hole shown
KRC-466R(M)_U.S r1 02.9.26 2:02 PM Page 27