Filter
Top Products
80 KOS-V500
When the unit fails to operate correctly, the
cause of the failure appears on the display.
Protect :
Protective circuit has been activated because a
speaker cord has shorted or it has come in contact
with the car chassis.
➡ Wire or insulate the speaker cord as appropriate
and then push the Reset button.
Hot Error :
When the internal temperature of this unit rises to
60°C or more, the protection circuit is activated and
you may not be able to operate the unit. At such
times this message will appear.
➡ Use the unit again after reducing the
temperature inside the vehicle.
Hold Error :
Activation of the protective circuit when the
temperature inside the disc changer is higher than
60 degrees Celsius stops the disc changer from
operating. At such times this message will appear.
➡ Use when the temperature at the site where the
disc changer has been fitted has dropped.
Error 07–67:
The unit is not operating correctly due to some
reason or other.
➡ Push the unit's Reset button. If the "Error 07−67"
message does not disappear, see your nearest
Kenwood dealer.
No Device (USB device)/Disconnected (iPod):
The USB device/iPod is selected as a source
although no USB device/iPod is connected.
➡ Change the source to any source other than
USB/iPod. Connect an USB device/iPod, and
change the source to USB/iPod again.
No Music:
The connected USB device contains no playable
audio file.
Media was played that doesn’t have data recorded
that the unit can play.
Help? Error
USB Device Error!!:
The connected USB device is rated a current
capacity higher than the allowable limit.
➡ Check the USB device.
Some trouble may have occurred to the connected
USB device.
➡ Change the source to any source other than USB.
Remove the USB device.
Authorization Error:
Connection to the iPod has failed.
➡ Remove the iPod and then reconnect it.
The unit does not support the iPod.
➡ Refer to <About iPod that can be connected to
this unit> (page 7).
Update your iPod:
The iPod's software is an older version which the
unit can not support.
➡ Confirm that the software for the iPod is the
latest version. Refer to <About iPod that can be
connected to this unit> (page 7).
EXT SW: Error:
Connection to the external device has failed.
➡ Remove the external device and then reconnect
it.
➡ Turn off the power or ACC and turn it back on.
You can connect only one iPod:
More than one iPod are connected to this unit.
➡ Disconnect all the iPods, and then reconnect
only one.