Kenwood VR-9060 Stereo System User Manual


 
47
EN
Notes
1.KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2.The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
Specifications
AUDIO section
Rated power output during STEREO operation
Effective power output during SURROUND operation
FRONT (20 ~ 20 kHz, 0.09 % T.H.D., at 8 one channel driven)
............................................................................... 100 W + 100 W
CENTER (20 ~ 20 kHz, 0.09 % T.H.D., at 8 one channel
driven) .................................................................................. 100 W
SURROUND (20 ~ 20 kHz, 0.7 % T.H.D., at 8 one channel
driven) ................................................................... 100 W + 100 W
SURROUND BACK (20 ~ 20 kHz, 0.7 % T.H.D., at 8 one channel
driven) ................................................................... 100 W + 100 W
Total harmonic distortion .......................0.009 % (1 kHz, 50 W, 8 )
Frequency response
CD/DVD..................................10 Hz ~ 100 kHz, +0 dB ~ –3.0 dB
PHONO ‘RIAA’ response..............40 Hz ~ 20 kHz, +1.5 dB ~ –3.0 dB
Maximum input level
PHONO (MM).................................. 40 mV, 1 % T.H.D., at 1 kHz
Signal to noise ratio (IHF’66)
PHONO (MM)........................................................................75 dB
CD/DVD................................................................................. 95 dB
Input sensitivity / impedance
PHONO (MM)...........................................................7 mV / 47 k
CD/DVD, MD/TAPE, AV AUX, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH
.............................................................................. 500 mV / 47 k
Output level / impedance
TAPE REC ...............................................................500 mV / 1 k
PRE OUT (SUBWOOFER) .............................................1 V / 1 k
Tone control
BASS................................................................ ±10 dB (at 100 Hz)
TREBLE............................................................ ±10 dB (at 10 kHz)
Loudness control
VOLUME at –30 dB level ......................................+6 dB (100 Hz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input level / impedance / wave length
Optical ..............................–15 dBm ~ –24 dBm, 660 nm ±30 nm
Coaxial...................................................................0.5 Vp-p / 75
Output level / impedance / wave length
Optical ..............................–21 dBm ~ –15 dBm, 660 nm ±30 nm
100 watts per channel minimum RMS, both channels driven,
at 8 from 20 Hz to 20 kHz with no more than 0.09% total
harmonic distortion. (FTC)
VIDEO section
VIDEO inputs / outputs
VIDEO (composite) ..................................................1 Vp-p / 75
S VIDEO inputs /outputs
S VIDEO (luminance signal) ...................................1 Vp-p / 75
S VIDEO (chrominance signal)....................... 0.286 Vp-p / 75
COMPONENT VIDEO inputs /outputs
COMPONENT VIDEO (luminance signal) ..............1 Vp-p / 75
COMPONENT VIDEO (CB/CR-signal) ...............0.64 Vp-p / 75
FM tuner section
Tuning frequency range................................. 87.5 MHz ~ 108.0 MHz
Usable sensitivity (MONO)
...........................1.3 µV (75 )/ 13.2 dBf (75 kHz dev, SINAD 30 dB)
50 dB quieting sensitivity
STEREO .............................. 28 µV (75 )/ 40.2 dBf (75 kHz dev)
Total harmonic distortion
MONO (1 kHz, 75 kHz dev) ..........................0.5% (65 dBf input)
STEREO (1 kHz, 67.5 + 67.5 kHz dev) .........0.7% (65 dBf input)
Signal to noise ratio
MONO (1 kHz, 75 kHz dev) ........................ 75 dB (65 dBf input)
STEREO (1 kHz, 67.5 + 67.5 kHz dev) ....... 68 dB (65 dBf input)
Stereo separation (1 kHz)........................................................... 40 dB
Selectivity (±400 kHz) .................................................................70 dB
Frequency response (30 Hz ~ 15 kHz) .................... +0.5 dB, –3.0 dB
AM tuner section
Tuning frequency range.................................... 530 kHz ~ 1,700 kHz
Usable sensitivity (30% mod, S/N 20 dB) .........16 µV / (600 µV/m)
Signal to noise ratio (30% mod, 400 Hz)
.................................................................. 50 dB (60 dBµV EMF input)
GENERAL
Power consumption ................................................................... 3.4 A
Standby Power consumption ..................................... Less than 1 W
AC outlet
SWITCHED......................................... (total 150 W, 1.25 A max.)
Dimensions..................................................... W : 440 mm (17-5/16")
H:166 mm (6-9/16")
D:396 mm (15-9/16")
Weight (Net) ............................................................ 12.0 kg (26.5 lb)
Caution : Read this page carefully to ensure safe
operation.
2/9/05, 11:55 AM47