Filter
Top Products
34
EN
The remote control supplied with this receiver is also capable
of controlling components from a variety of manufacturers
once you register the appropriate setup codes into the
remote control unit.
Registering setup codes for other components
REMOTE SETUP
TV MODE
LED
TV
Source keys
Numeric keys
SOURCE (power)
1
Find the setup code of the component to be registered.
•Refer to the setup code lists to find the setup code for the
component to be registered. fl
Example: To register a DVD made by KENWOOD, you would enter
“0534”.
Input jack Component Maker Code Key
DVD/6CH DVD player KENWOOD 0534 DVD 6CH
Source key Other components
TUNER Receiver (KENWOOD)
DVD/6CH DVD
CD/DVD CD and MD (KENWOOD)
MD/TAPE CD and MD (KENWOOD)
VIDEO 1 / AV AUX VCR and PVR
VIDEO 2 Cable and DTV decoder
VIDEO 3 DSS
PHONO Additional key for re-assigning
TV MODE TV/VCR combo, TV/DVD combo, TV
2
Press the Source keys (DVD/6CH, VIDEO 1, VIDEO 2, VIDEO 3,
CD/DVD, MD/TAPE, PHONO, AV AUX, TV MODE).
•PHONO key has to re-assigned to another key before a setup code
can be registered. fl
•While in Tuner mode, setup code function will not be available.
3
Press and hold the REMOTE SETUP key until the LED blinks
twice, then release the REMOTE SETUP key.
4
Press the Numeric key to enter the four-digit code for the
component to be registered.
•If performed correctly, the LED will blink twice.
•Point the remote control at the component and press
SOURCE
key once. It should turn on/off but if it does not, repeat step 2 to 4
•If the component still does not work, try searching for the code.
5
Repeat steps
2
to
4
to register additional components until
all components have been registered.
Note
Although each setup code is designed to work with a number of
different models, certain codes may not work with some models.
(Also, certain codes may only operate some of the functions available
on a given model.)
Searching for your codes
If your component does not respond after trying all the codes listed for
your component, or if your component is not listed at all, try searching
for your code.
For example, to search for code for your TV:
1
Press the TV MODE key once. Next, press and hold the
REMOTE SETUP key until the LED blinks twice, then release
the REMOTE SETUP key.
2
Press the Numeric key to enter
9
,
9
,
1
.
•The LED will blink twice.
3
Point the remote control at the TV and slowly alternate
between pressing the
TV and TV MODE keys.
•Stop when the TV turns on or off.
•In the search mode, the remote control will send IR codes from its
library to the selected device, starting with the most popular code
first.
4
Press the REMOTE SETUP key once to lock in the code.
5
To search for the codes of your other components, repeat
steps
1
through
4
, but substitute the appropriate key (i.e.,
DVD/6CH, VIDEO 1, VIDEO 2, VIDEO 3, CD/DVD, MD/TAPE,
PHONO, AV AUX, TV MODE).
•PHONO key has to be re-assigned to another key before a setup
code can be programmed.
Basic remote control operations for other components
Low battery warning
Replace all two batteries with new ones when you notice a shortening
of the distance from which the remote control will operate. The
remote control is designed to retain setup codes in memory while
you change batteries.
2/9/05, 10:28 AM34