Filter
Top Products
18
Preparations
Setting up the system
1 Display operation 1 key
Use this key to go back to the previous display or initial display.
2 Display operation 2 key
Gets you into and out of the preset code registration mode.
3 Display
The information for setup is displayed.
4 5/∞ keys
Use these keys to select the source or setup code.
5 MOVIE, MUSIC, and TV keys
Use these keys to select the input you want to register.
6 AV POWER key
Once you have entered the setup code for another component, you can
press this key to turn power to that component on or off. This lets you
confirm that you entered the code properly.
How to use the display operation keys
To register the setup code, use the display operation 1 key, display
operation 2 key, or
5/∞ keys.
The display operation 1 key and display operation 2 key work as the
function key displayed in the display above.
The display goes off automatically when you do not operate for more than
8 seconds. In this case, press the display operation 1 key, display
operation 2 key, or 5/∞ keys.
When the display goes off
Press the display operation 1 key repeatedly until “Menu” appears in the
display.
The display returns to the initial display.
When you are confused about what’s being displayed
>06.Cable
>05.VCR
Back Enter
The display operation 1 key
•[Back]
Go back to the previous display.
•[Home]
Go back to the initial display.
•[Clr]
Erase the internal memory.
The display operation 2 key
• [Enter]
Enter the selected item.
• [Menu]
Display the menu.
• [Setup]
Go to the setup display.
• [Exit]
Exit from the current operation.
• [Sel]
Select the item.
Display operation 1
5/∞
Display operation 2
+
—
+
—
Display
SHIFT MACRO
MUSIC
LISTEN M.
BASS BOOST SUB W.
MUTE
CH.
CH.
VOL.
VOL.
TUNING
BAND
ENTER
AUTO/MONO
REC MODE
F.SHIFTREC LEARN
RANDOMREPEAT INPUT SEL.
213
546
879
0+10 +100
1110 12
DISPLAYTV SELECT SELECT
THEMEAUDIO FAVORITE
EXITINFO. LAST CHANNEL
OSD
/PAGE
RETURN
/PAGE
DIMMER
TITLE/GUIDE MENU
SOUND
CINEMA EQ
MOVIE TV
AV POWER SYS. POWER
RF REMOTE CONTROL UNIT
RC-R0811
The remote control sends an RF (radio wave) signal to the receiver. For
equipment other than the receiver, an IR (infrared) signal is sent. For the
operation of the RF remote function, see page 18 and 19 of the instruction
of the unit.
The remote control supplied with this receiver is also capable of control-
ling components from a variety of manufacturers once you register the
appropriate setup codes into the remote control unit.
Refer to “Remote operation of other components” for details about the
operations available for each component.
‚
*509/07-18/EN 3/15/01, 2:01 PM18