Filter
Top Products
piiiaKE
locked in place. Otherwise it may fall out of
place when jolted.
l When extending the ignition, battery, or
To prevent injury or fire, take the
ground wares, make sure to use automotive-
following precautions:
grade wires or other wires with a 0.75mm’
(AWG18) or more to prevent wrre
l Insert the unrt all the way In untrl It is fully
deterioratron and damage to the wrre
coating.
12V DC power supply.
l Do not open the top or bottom covers of the
piii%Eq
unit.
To prevent damage to the machine,
take the following precautions:
l Make sure to ground the unit to a negatrve
l Do not install the unit In a spot exposed to
direct sunlight or excessive heat or humidity.
Also avoid places with too much dust or the
possrbilrty of water splashing.
l Do not set the removed faceplate or the
faceplate case in areas exposed to direct
sunlight, excessive heat or humrdrty. Also
avoid places with too much dust or the
possibility of water splashing
l To prevent deterioration, do not touch the
terminals of the unit or faceplate with your
fingers.
l To prevent a short circuit, never put or leave
any metallrc objects (such as coins or metal
tools) Inside the unit.
l If the unit starts to emit smoke or strange
smells, turn off the power immedrately and
consult your Kenwood dealer.
l Make sure not to get your fingers caught
between the faceplate and the unit.
l Be careful not to drop the unrt or subject It to
strong shock
The unit may break or crack because It
contarns glass parts.
l Do not touch the liquid crystal flurd if the
LCD IS damaged or broken due to shock. The
liquid crystal fluid may be dangerous to your
health or even fatal.
If the liquid crystal flurd from the LCD
contacts your body or clothrng, wash It off
with soap immediately
l Do not subject the faceplate to excessrve
shock, as it is a piece of precrsron
equipment.
l When replacing a fuse, only use a new one
with the prescrrbed rating. Usrng a fuse with
the wrong rating may cause your unit to
malfunction.
0 To prevent a short clrcurt when replacing a
fuse, first disconnect the wrring harness.
l Do not place any object between the
faceplate and the unrt.
l Do not use your own screws. Use only the
screws provided. If you use the wrong
screws, you could damage the unit.
IMPORTANT INFORMATION
About the disc changer to be
connected:
To connect a disc changer having the “O-N”
switch to this unit, set the “O-N” switch to “N”.
To connect a disc changer having no “O-N”
swatch to this unit, the converter cord CA-
DSIOO and/or switching adapter KCA-S210A
are required as options.
A disc changer doesn’t work when It
IS
connected without using these options.
If a model with no “O-N” switch IS connected,
some unavailable functions and rnformatron
that cannot be drsplayed are generated.
Note that none of the KDC-CIOO, KDC-C302,
C205, C705, and non-Kenwood CD changers
can be connected.
A
You can damage both your unit and the CD
changer If you connect them rncorrectly
Do Not Load 3-in. CDs in the CD slot
If you try to load a 3 in. CD wrth Its adapter
into the unit, the adapter might separate from
the CD and damage the unrt.
-4-