Filter
Top Products
The messages shown below display your systems
condition.
E-01 : No disc magazine has been loaded in the changer.
The drsc magazine IS not completely loaded.
c: Load the drsc magazine properly.
No CD in the untt.
c: Insert the CD.
E-02: No disc has been loaded in the disc magazrne.
1: Load a disc into the drsc magazine.
E-04: No disc has been loaded in the disc magazrne.
1: Load a drsc Into the disc magazrne.
The CD IS quote dirty. The CD IS upside-down. The CD
IS scratched a lot.
ct Clean the CD and load it correctly.
E-l 0:
E-l 1:
Nothing has been recorded on the MD.
No tracks are recorded on the MD, although It has a
title.
E-l 2.
The faceplate of the slave unit being connected to
this unit has been removed.
a: Replace It.
E-77
The unrt is malfunctronrng for some reason
a: Press the reset button on the unrt If the “E-77”
code does not disappear, consult your nearest
servrce center
E-99.
The unit IS malfunctrcnrng for some reason
8: Press the reset button on the unit. If the “E-99”
code does not disappear, consult your nearest
servrce center.
E-Od:
The protective crrcuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (14O”F), stopping all operation.
r, Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (14O”F), the disc will start playrng
again.
LOAd:
IN (Blink):
Discs are being exchanged in the Disc changer
The CD player section
IS
not operating properly.
I: Reinsert the CD. If the CD cannot be ejected or the
display continues to flash even when the CD has
been properly reinserted, please switch off the
power and consult your nearest service center.
- 23 -