Kenwood KDC-X869 CD Player User Manual


 
English
— 54 —
What might seem to be a malfunction in your unit may
just be the result of slight misoperation or miswiring.
Before calling service, first check the following table
for possible problems.
General
? The power does not turn ON.01
The fuse has blown.
After checking for short circuits in the wires, replace the fuse with
one with the same rating.
? There’s a source you can’t switch.07
There’s no media inserted.
Set the media you want to listen to. If there’s no media in this
unit, you can't switch to each source.
The Disc changer isn’t connected.08
Connect the Disc changer. If the Disc changer isn’t connected to
it's input terminal, You can't switch to an external disc source.
? The memory is erased when the ignition is turned OFF.10
The ignition and battery wire are incorrectly connected.11
Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals>.
? There’s no loudness effect.12
You’re using Non-fading preout.
Loudness has no effect in Non-fading preout.
The <System Q> (page 12) is set to SRS WOW.12-1
Turn it to the other items.
? Even if Loudness is turned ON, high-pitched tone isn't compensated
for. 17
Tuner source is selected.
High-pitched tone isn't compensated for when in Tuner source.
? The Bass center frequency, Bass quality factor, Bass extend, Middle
center frequency, Middle quality factor, and Treble center frequency
can’t be adjusted.19
The <System Q Setting> (page 43) is set OFF.
Set it ON.
? No sound can be heard, or the volume is low.
The fader or balance settings are set all the way to one side.21
Center the fader and balance settings.
The input/output wires or wiring harness are connected incorrectly.22
Reconnect the input/output wires or the wiring harness correctly.
See the section on <Connecting Wires to Terminals>.
The values of Volume offset are low.24
Turn up the Volume offset, referring to the section on <Audio
control> (page 12).
The <Built-in Amp Mute Setting> (page 44) is ON.100
Turn it OFF.
? The sound quality is poor or distorted.25
One of the speaker wires is being pinched by a screw in the car.
Check the speaker wiring.
The tape head is dirty.26
Clean the tape head.
The speakers are not wired correctly.27
Reconnect the speaker wires so that each output terminal is
connected to a different speaker.
? Non-fading output, Non-fading Low Pass Filter and Non-fading
setting can’t be done.28
The <Non-fading output> (page 12) is OFF.29
Turn it ON.
The <Dual zone system> (page 26) is ON.30
Turn it OFF.
? There’s no Front High Pass Filter and Rear High Pass Filter effect.31
The Non-fading preout is being used.
There’s no effect in Non-fading preout.
? The Touch Sensor Tone doesn’t sound.34
The preout jack is being used.
The Touch Sensor Tone can’t be output from the preout jack.
? Even though Synchronize Clock is ON, the clock can’t be adjusted.35
The received RDS station isn’t sending time data.
Receive another RDS station.
Troubleshooting Guide
KDC-X969_U.S_r4.pg 02.12.13 4:45 PM Page 54