Filter
Top Products
Application section
HM-331 (En/T)
35
Program recording (CD
=
TAPE)
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Recording preparation is required.
™\
(Be sure to put the cassette deck in stop mode.)
Convenient Recording Methods
1
Start recording.
2
CD
=
TAPE
Perform steps 1 and 2 of the procedure in
”Listening in the desired sequence (Program
playback)”.
¢
÷ When the PGM key is pressed to cancel the edited
contents, the entire editing contents will be erased.
÷ Tracks programmed in excess of the tape recording time
will be cut off.
÷ Recording of the programmed tracks in the programmed order starts.
÷ To perform operation on the main unit, see step 3 in the procedure in ”One-touch recording”.
›
Program the desired sequence of CD tracks.
O.T.E.
TAPE
7
To interrupt a recording
(Recording and playback will be
stopped.)
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.