Filter
Top Products
107
■ Using the MCP-1A Software
When the transceiver is connected to a PC in order
to use the MCP-1A (Memory Channel Control
Program) software, you must configure the SP/MIC
jack function prior to using the software.
1 Press [MENU].
2 Turn the Tuning control to select Menu No. 31
(PC).
3 Press [MENU].
4 Turn the Tuning control to select “ON”.
5 Press [MENU] to store the setting or press [PTT]
to cancel.
6 Press any key other than [LAMP], [MONI/SQL],
and [MENU] to exit Menu Mode.
Note: If you use an optional Speaker/ Microphone after using
the MCP software, select “OFF” in step 4. Otherwise, the
Speaker/ Micrphone does not function properly.